G.hn Ethernet Over Coax Adapter Kit - 1.2Gbps Network for Unused/Dark Coax - Secure Wired Connection for Gaming & Streaming - Easy Setup - Not for Cable TV

Habe das Kit am Freitag bestellt. Montag war es da. Lieferung aus USA. Einrichtung bzw. In Betrieb nähme verlief ohne Probleme. Wie hier schon beschrieben benötigt man andere Netzteile oder Adapter von US auf EU Stecker. Die Webinterfaces sind über die IP 192.168.0.5 zu erreichen. Ich komme nach Test mit iperf auf Fritzbox auf 300MBit. Da ist bestimmt noch Potential nach oben. Für mich eine gute Variante ohne neue Kabel zu legen das WLAN dort hinzubekommen wo ich es benötige. AP angeschlossen und gut.

This was exactly what I needed to boost speed on my mesh system. I have a fairly decent mesh system, but it was slow in the upstairs of the house. I have a fiber service and the only place they could put the ONT was in a very far back bedroom. Well, the signal just didn’t reach well enough throughout the house to give me a decent speed. This on the other hand was exactly what the doctor ordered. Occasionally I now have my full speed of 500 Mb per second (generally about 400 upstairs) where I was only getting 200 Mb wirelessly. Installation was very simple. I thought there was some button I had to push to pair these: not at all. I connected the one downstairs in the bedroom to the cable, came upstairs attached that to the cable outlet and boom it was done they paired and it works flawlessly. Plus, the fact that Amazon reduced the price by 20% made it affordable for me so this was a no-brainer. I definitely can recommend this product.

Installation was a breeze. Easy to pair and setup and it secured my network with encryption so that no one else could tap in. Transfer speed and stability is far better than my former bonded MoCA pair. Truly plug and play!

Pretty simple plug and play but I had a hard time getting them to pair . But otherwise work as intended went from 40mbps wifi to 500mbps with this Ethernet over coax system. Note : If you have issues with them pairing ie. the connection light won’t come on , then directly connect them with a coax cable (plug into the “In” port on both the TV port is only used for older TVs ) while one is plugged into the router via cat-6-8 cable then press the config button for 5 seconds on both units . After the secure light and Ethernet light start blinking let them sit for a few minutes instructions say 10 seconds but it took a lot longer for mine to pair. Once the connection light is on and green you are good to take the unit that is not connected to the router to the device you intend to install it on . You may need to press the config button on both of them again .

Funktioniert bislang ohne Probleme. Würde ich wieder kaufen.