SN65HVD230 CAN Bus Module Communication Module CAN Bus transceiver

Worked fine. FYI surface-mount termination resistor is soldered in place (easy to remove if necessary).

Bought two of these because I thought the form factor would be convenient over Waveshare's offering. Both were duds. While the Tx and Rx lines seemed to work (sending would result in a confirmation on the rx side), the CAN H and L sides were stuck at 1.65V while transmitting, and nothing came out of Rx while receiving.

I really wish there was an option to get these WITHOUT the 120ohm resistor on-board. The description states "allowing 120 nodes" but with that resistor on the board, it makes it so that no more than two can be used on any CAN bus. Please update the product description to the current configuration.Desoldering these by hand is a pain.

The other review is correct there is a 120 ohm resistor across the bus however it is easy to remove. Will run at 3.3V or 5V even though 3.3 is recommended. (data sheet allows up to 5.5V MAX) Using with stm32f4 works fine.

Works great with a Teensy 3.5. Removed terminating resistor with a soldering iron.