Attwood 4650-7 Tsunami T800 Aerator Pump, 800 GPH, 12-Volt, 3 ½-Inch Long Inlet, Threaded ¾-Inch Diameter Outlet, 29-Inch Wire

I inherited an older boat with a ton of little issues, including a livewell pump that was completely shot. I'm not super handy or boat-savvy, but swapping in this Attwood Tsunami aerator pump was surprisingly straightforward. No major headaches or special tools needed. Once I got it installed and out on the water, I was really impressed. It fills the livewell super quick, keeps the water moving well, and my bait and fish have stayed lively without any problems. It's also pretty quiet and runs smooth with just a low hum, nothing annoying or loud like some pumps I've heard about. Zero complaints so far. For longevity (since I've heard these can get clogged in weedy water), I added a wide screen over the intake to block weeds and junk. Fingers crossed it lasts a long time with that extra protection. If your old pump died and you're looking for an easy, reliable replacement, this one's a solid choice. Definitely worth it!

Further updates , we caught a bunch of livies and filled the livewell tank the pump ran for around 6 hours and the fish were happily swimming around in the tank. I also found that the tank filled whilst the boat was moving without the battery attached. update we went out for a fishing session today tues.26th nov. Great conditions 5 knot variables. We didnt get any livies but were able to fill the livewell tank real quick. We had a good session and had 9 snapper in the bin . I set up the washdown hose and washed the fish as i went scaling and gutting. The livewell was cycling at the same time no problems i had plenty of flow. The pump was quiet and used little power. So far i am really happy with my buy. The pump was still able to supply water to the livewell whilst moving spots at around 20 knts. I was going to buy the t800 with 2 outlets ,but I would have needed to drill 2 holes in the aluminium outboard well .So I got this one and added a tee after so I could run 2 hoses, 1 for a live well and the other for a wash down hose. Both hoses have valves to turn on or off or reduce flow. Using the Attwood mounting bracket it was really quick and easy to mount to my transom under the board platform. The intake is below the hull and have cut an angle in the tube facing forward to enable water entry whilst under way.i am happy with the clean set up and trust that I can rely on a quality product. I hope to use it next week .

Great price plug and play installation

Product is exactly as described

Worked for my husband vehicle. That’s all that I know lol

Used this product to replace the stock empty pump on my boat ballast bags. Boat is a 2007 Moomba XLV. This product should fit most Supras and Moombas. Old pump failed and I needed a good replacement. This product worked very well. Doesn't require priming and hasn't air locked on me at all. Installation was easy and all fittings were compatible. I plan to buy 2 more to replace the rear ballast pumps. You can adjust the length of the threaded part with a hacksaw if needed. Fine product, would buy again.

This is the aerator used in the Seadoo Fish Pro 2017! Mine broke due to salt and bouncing on the waves, and I nearly drowned, but getting the replacement was easy. However, installation is not for everyone, as it is located in a very hard-to-reach place.

EDIT UPDATE 2016-12-02: Used the pump for one full season now. For me, that's about 28 days out fishing in that boat, using the pump. Pump is still working strongly, smoothly, and quietly. Can't guarantee it's pumping 800GPH, but it pumps a lot of water pretty quickly! Could be 800GPH; no reason to think it isn't. I would guesstimate the pump ran about 50 hours of actual pumping. Most of that is in 1 minute bursts every 3-5 minutes. On one particular trip, the pump runs full time for 1-2 hours at a pop, about 3-4 times on the trip. The *REST* of the time it runs day and night on 'intermittent' mode, about one minute spray every 5 minutes, because we're keeping large live bait in the livewell for catfishing. And like I said, it's still running strong and quiet. ----------------------------------------------------------------------------------------------------------------------------- INITIAL REVIEW (made immediately after purchase as a 'buyer beware' type thing): The reason I am writing a review so soon after purchase is to possibly help someone else avoid the issue I had. I waffled back and forth between the 800GPH and the 1200GPH model. I had both in my cart, and decided what the heck... I went with the 1200. BUT what I didn't realize was that the input and output sizes CHANGED from 3/4" on the 500 and 800, to 1 1/8" on the 1200. On discovering the problem (with my head down in the bilge area of my boat failing to get the pump intake pipe thru the transom), I crawled out and went back to the Amazon page where I ordered it and DID see a little bullet item at the top when the 1200 was selected, saying that it was 1 1/8". So it was my own fault, but I'm guessing other folks might not notice like I didn't, OR might not REALLY realize what that means... Most aluminum boats under 22' have 3/4" diameter input/output livewell pump fittings. So if you buy the 1200, you have some serious work to do to make it usable, including drilling the current 3/4" transom hole out to 1 1/8" (which is likely to be difficult). Also the 3/4" hose going to the livewell sprayer won't fit on the pump output. So you'll need to replace that hose, or get a 'converter' to take the pump output down from 1 1/8" to 3/4", which will restrict the pump output, and might stress the pump.

Excelente producto muy buena calidad

Pumpe hatte bei Anlieferung einen technischen Schaden (Wackelkontakt)

Works perfectly and was easy to install as a replacement for a pump that had failed.

Todo perfecto

Bon prix